TAGGED
Moku
3 designs tagged “Moku”.
Desk & office / Organizers / Modular
Moku Iris Box — Working Camera-Aperture Catch-All (Base Rail module)
A round fluted catch-all box for the Moku modular desk system whose lid is a WORKING 6-blade iris diaphragm — twist the knurled collar and the blades spiral open like a camera aperture onto the cavity (Ø48 mm) for clips, SD cards and coins. Same-plane pinwheel iris: 6 identical rigid blades on pivot posts, drive pins riding radial collar slots, snap-on collar, 1-minute no-order assembly, zero supports. Clips onto the host Base Rail by the reverse-measured foot interface. A remix of the Moku Base Rail by @SabreDesign / @Collecticraft.
Desk & office / Organizers / Paper Notes
Moku Memo Stand — Sloped Sticky-Note Writing Tray (Base Rail module, 3 sizes)
A sloped sticky-note writing tray that clips onto the Moku modular desk-system Base Rail. The pad sits on a 21° incline so the top sheet faces you — read it and write on it in place. Low front rim plus a centre finger-scoop to peel the top sheet; tall back and side rims keep the pad square. Three pad sizes (60 / 80 / 90 mm) and both rail orientations (slide on from the side or front/back) are bundled. Japandi fluted side faces to match the Moku look. A remix of the Moku Base Rail by @SabreDesign / @Collecticraft.
Jewelry & accessories / Jewelry displays
Moku Cantilever Watch Stand — open 'C' bracket + parametric engraved clock (Base Rail module)
A cantilever 'C' watch stand for a chunky sport/dive watch that clips onto the Moku modular desk-system Base Rail. A soft, near-rectangular bracket with smoothly filleted joints: a back spine carries a top arm that cantilevers forward over an open gap, its rest face CANTED ~20° SIDE-TO-SIDE so the watch leans on a dynamic diagonal. The watch sits centred over the base (so a heavy steel watch won't tip it off the rail); the bracelet drapes over the rounded front nose and hangs free, its end on the front shelf. The tall SPINE FRONT face — the back wall of the C, in full view through the opening — carries an ENGRAVED CLOCK FACE with PARAMETRIC hands (set the time in the SCAD, default 10:10) ringed by gear teeth. Every edge is rounded (Japandi). Prints PRINT-ON-END so the cantilever needs no supports and the rail foot prints as crisp vertical channels. A remix of the Moku Base Rail by @SabreDesign / @Collecticraft.