TAGGED
Caddy
5 designs tagged “Caddy”.
Decorations / Coasters
Biohazard Coasters — raised trefoil that lets go of a wet glass, plus caddy
Ø90 mm coaster set with the biohazard trefoil standing 0.8 mm proud of the drink face, so a cold wet glass rests on three lobes and never suctions to the floor. Two-colour AMS file with the six-island mark pre-welded into ONE part, a single-colour version, and a stacking caddy for four. No supports.
Decorations / Coasters
Halloween Coasters — six motifs that hold the glass 0.6 mm off the coaster, plus a pumpkin caddy
Ø90 mm Halloween coaster set: jack-o'-lantern, ghost, bat across a full moon, spider web, skull and cauldron. Every motif stands 0.6 mm PROUD of the drink face, so a cold wet glass rests on it with air underneath and never sticks and lifts the coaster with it. Two-colour AMS files that split into exactly two parts, a single-colour version of each, and a ribbed pumpkin caddy that stacks five fully, with the sixth above the rim. No supports anywhere.
Kitchen / Drink Holders
Lazy-Susan Drink Turntable — 4-cup, drop-in ball bearing
A spinning drinks caddy that keeps turning smoothly even loaded with full cups. The cup weight rides on a ring of drop-in steel balls (NOT printed) so friction stays low under load. Print two parts, drop in cheap 8 mm balls, set the top on — done. Four 90 mm cup wells fit mugs and pint glasses. Parametric OpenSCAD source included.
Desk & office / Organizers / Pen Holders
Retro Tape Deck Desk Caddy — pen cups, phone dock, pull-out cassette drawer + swappable spine labels
A 1980s stereo cassette deck that is actually a desk organiser. Two 52 mm-deep pen cups, a catch-all tray, a tilted phone cradle with a cable pass-through, and a pull-out 'cassette' drawer whose spine label is a card you thread in sideways and swap. 9 spare captions on one sheet — or letter your own straight from the parametric OpenSCAD source. 3 printed parts, no hardware, no glue, no supports.
Desk & office / Electronics / Cables
USB Drive Caddy — Hex-Grill Open-Front Cubby
N×M open-front cubby for low-profile USB-C 'disc' drives. Drives lay flat and slide in from the front; ~4 mm sticks out for pinch removal. Decorative hex perforation on top + sides. Ships pre-rotated — open face prints UP, back wall on the bed, zero supports.