TAGGED
Dangle
3 designs tagged “Dangle”.
Jewelry & accessories / Earrings
Articulated Worm Dangle Earring — Print-in-Place Flexi Worm
A tiny ~38 mm print-in-place worm that actually wiggles and sways when worn. Five segments linked by captive teardrop ball-socket joints — printed flat, belly-down, NO supports, then flexed free. Friendly face with eyes + an engraved smile, and a flat ear loop in the bed plane so it hangs in classic worm side profile. Print twice for a pair.
Jewelry & accessories / Earrings
Raven Skull Earring — flat silhouette dangle, mirrored pair, no supports
A raven (Corvus corax) skull in lateral profile as a flat dangle earring: a big domed braincase pierced by an Ø8 orbit, the heavy decurved corvid culmen with an open nare, and a mandible fused only at the articulation so an open jaw slot runs the length of the beak — that slot is what makes it read as a skull rather than a bird head. One flat piece, ~25 x 41 x 1.8 mm, 0.93 g, printed face-up with zero overhangs and no supports. Ships mirrored left and right STLs so a worn pair both faces outward, and a fully parametric OpenSCAD source: size, thickness, hang angle, orbit and nare, bail hole.
Jewelry & accessories / Earrings
Tiny Book Earring — a wearable book that really opens, print-in-place hinge, no supports
A book small enough to wear that actually opens. One print-in-place piece: two covers on a seven-knuckle piano hinge with a captive pin, a hollow page cavity inside, and ONCE UPON engraved on the inner cover so the message only shows when you open it. 22 x 17.6 x 4.2 mm closed, 1.55 g, about 25 minutes, no supports and no hardware beyond an ear wire. Comes off the plate open flat; fold it once and it clicks shut on a printed detent bead, and a thumbnail in the fore-edge scallop pops it open again. Fully parametric OpenSCAD source — size, cover thickness, hinge clearance, detent grip and the engraved message are all variables.