TAGGED
Hook
7 designs tagged “Hook”.
Around the home / Hooks
Bat Ceiling Hook — hangs by its own feet, head down, like a real bat
A roosting bat that hooks over a ceiling hook by its two toe-rings and gives you two open claw hooks at the bottom for cords, string lights or a planter. One part, no supports, no assembly.
Around the home / Hooks
Cerberus leash hook — three-headed hellhound wall plaque with hidden magnets
A three-headed hellhound wall plaque where each open jaw is a hook. Five magnets sit fully sealed inside the body, dropped in at a print pause, so the back face is one unbroken plane with no bores, no glue and nothing to fall out.
Desk & office / Organizers / Modular
MagDock — Magnetic Desk & Shop Organizer Family
A family of small organizers that embed neodymium discs in their backs, so they snap onto ANY ferrous surface — printer frame, fridge, toolbox, filing cabinet, radiator. Hook, tray, tall caddy, pliers/scissors slots, and a bare puck. The magnets are sealed inside DURING printing (mid-print pause), so no caps and no glue. Every part prints flat on its back with NO supports.
Around the home / Hooks
Radiator Hook — S-Hook for Towel Radiators (No Drilling, No Hardware)
A chunky plastic S-hook that slips over the top rail of a heated towel radiator and carries a towel, glove, bag, or keys on the bottom. No drilling, no adhesives, no metal hardware — one-piece print, flat on the bed, no supports.
Around the home / Hooks
Cap Magnet Hook
A little magnetic hook shaped like a baseball cap — the curved brim is the hook. Two Ø10x5 mm neodymium discs sit sealed inside the flat back and stick it to any steel surface (fridge, locker, radiator, steel door frame). No screws, no supports. A screw-mount version is included too. Holds LIGHT things only.
Around the home / Hooks
Bag Hook for a Desk Edge or a Chair Back
Clamps onto a table edge, a desk lip or a chair backrest and gets the backpack off the floor. One part, no supports, no screws, no glue. Three sizes included — 20, 25 and 30 mm jaws — and a sprung tongue inside each takes up the slack below that, so between them they cover roughly 10 to 30 mm. A 7-minute fit-test coupon is included for every size so you can check the grip on your own table before printing the whole thing. The source file is included and fully parametric: change one number and you get a jaw for any thickness.
Kitchen / Sink Organizers
Sink-Rim Sponge Tray — Hooks Over the Rim, Drains Into the Basin
Single-bay sponge tray that hooks over a kitchen sink rim and hangs inside the basin. Sized to a standard kitchen sponge (~95×60×25 mm) with ~5 mm slack on every side. Floor drain slots + lower-wall drains let water run straight back into the sink — sponge dries instead of sitting in a puddle. Prints in one piece, open-top up, no supports.